Gaming

Razer Wolverine V4 Pro swaps TMR for capacitive sticks

By | Published

On 6 October Razer announced the Wolverine V4 Pro, a wireless controller for Xbox and PC that replaces the TMR thumbsticks of the previous generation with capacitive sensors. Razer says they deliver higher resolution, better power efficiency and more resistance to magnetic interference than TMR and Hall effect sticks. A wired version, the Tournament Edition, launches alongside it.

What Razer announced

According to the official press release, these are the key specs of the Wolverine V4 Pro:

  • Thumbsticks: two contactless capacitive sensors paired with a 16-bit converter that registers around 3,000 steps of movement (measured on PC at 8,000 Hz with the wireless dongle).
  • Polling rate: up to 8,000 Hz on PC, wired or wireless. On Xbox Series X|S it is 250 Hz.
  • Triggers: a rear switch toggles between near-instant actuation and full analog travel. The actuation point can be set in Razer Synapse from 1.3 to 8.2 mm.
  • Extra inputs: four magnetic, swappable back buttons, two additional bumpers and PBT face buttons.
  • Settings: four onboard profiles and an adjustable dead zone from 0 to 15%.

The announced price is $199.99 or £199.99. The sources we checked do not list a euro price yet.

The same race we see in keyboards

The controller matters less than the trend behind it. Thumbsticks have moved from parts with physical contact to magnetic sensors (Hall effect and TMR), and now Razer is betting on capacitance. The pitch is always the same: no contact means no wear, and no wear means no drift, the ghost movement that shows up when a stick does not return exactly to center.

Keyboards are going through something similar. Classic mechanical switches now share the market with magnetic ones that let you choose in software where each key actuates. The Wolverine's 1.3 to 8.2 mm trigger adjustment is that same idea applied to a controller. Earlier this week we covered a different route to it on mechanical boards: GMK TriggerKey keycaps, which tune actuation with a physical lever and no switch change.

What to check before buying

If you switch between controller and keyboard depending on the game, this launch highlights three things:

  1. The platform sets the ceiling. 8,000 Hz only exists on PC. On console the same controller runs at 250 Hz, so that number should not drive the decision if you play on Xbox.
  2. The sensor benefits are the manufacturer's claims for now. GamesRadar points out that this stick type has no long-term track record and that the shell looks nearly identical to the V3 Pro. Until independent testing arrives, drift resistance is a promise.
  3. Know what depends on software. Fine trigger tuning happens in Synapse; whatever you store in the four onboard profiles goes with the controller to other machines.

Where TESSEN fits

The TESSEN keyboard takes the mechanical route: lubed linear Gateron KS-3 Milky Pro Yellow switches on a hot-swap plate that accepts 3- and 5-pin MX switches (not low-profile or optical). If you ever want a different feel, you swap switches without soldering. Per-key RGB with 18 effects works without installing any software.

It is a 61-key ANSI 60% board, a size that frees up desk space for your mouse or controller, as we explain in our 60% keyboard guide. To make it yours, the 3D configurator lets you paint each key in 8 colors and save the design with its own Design ID.

Sources

Gaming

Keep reading

All newsAll guides