Keyboards

Keybytes: an open-source keyboard with magnetic keys

By | Published

Keybytes is an open-source keyboard where every key is a separate module that snaps to its neighbours with magnets, like building blocks. It was created by Nathan Alspaugh, a first-year student at MIT, and was covered by The Register (26 October) and Tom's Hardware (27 October). For now it is a DIY project, not a product you can buy.

How it works

The system has two parts, both the size of a standard key (19.05 mm per side):

  • Keybit: the key. It carries a Cherry MX switch on top and its own RISC-V microcontroller (a CH32V003, according to Tom's Hardware). Spring-loaded pogo pins on all four sides pass power and I2C data to the next key.
  • Keyword: the controller. It coordinates the keys and talks to the computer. It is two stacked boards in the footprint of a single key; Tom's Hardware reports that the top board holds an Arm Cortex-M4 microcontroller, a Bluetooth antenna and flash memory, and the bottom one handles USB-C and charging.

The designs are on GitHub under the MIT licence, which lets anyone copy, modify and reuse them.

What it costs today

The numbers come from the creator himself. Each Keybit costs a couple of dollars and each Keyword around $30. For his prototype, board assembly came to $69 for the Keybits and $203 for the Keywords. A full-size board, with 2 Keywords and about 110 keys, would cost around $900 assembled.

Alspaugh says he has spent roughly 100 hours on it and is thinking about selling them once the designs are finalised. There is still work to do: he has had trouble with magnets that would not stay in place, and the keys have no lighting.

What it means if you use a keyboard every day

Keyboard customisation has grown in layers: first keycap colours, then switches on hot-swap boards, and lately the actuation point, as with GMK TriggerKey. Keybytes points at the next layer: the layout itself. With loose keys you could build a 60% for your desk, split it in two halves to type with your shoulders more open, or keep just a macro block next to your mouse, and change it whenever you like.

The price also shows why keyboards are not built this way. A microcontroller and connectors in every key multiply parts and assembly, while a single PCB holding every key is far simpler to manufacture. If what you want is a different feel, you do not need to go that far: on a hot-swap board you pull a switch and fit another without soldering, as our hot-swap keyboard guide explains.

One practical point matters already: since each Keybit uses a Cherry MX switch, any MX-mount keycaps you own would fit on top. It is one more reason the MX standard is worth sticking to: what you buy for one keyboard carries over to the next.

And on a TESSEN?

TESSEN is a 60% ANSI board with 61 keys and a fixed layout, built on the same standard base: a hot-swap plate for 3- and 5-pin MX switches (not low-profile or optical) and PBT doubleshot keycaps with MX mount. You can swap switches and keycaps without soldering, and in the 3D configurator you paint every key in 8 colours and save the design with its Design ID. If you are weighing up sizes, our 60% keyboard guide covers what you gain and lose with 61 keys.

Keybytes is not a keyboard you will have on your desk this year, but it is an idea worth following: a keyboard you rearrange instead of replacing.

Sources

Keyboards

Keep reading

All newsAll guides