Keyboards

Switch Lab lets you hear 100 switches in your browser

By | Published

Switch Lab is a website that collects 100 mechanical keyboard switches with recorded sound so you can compare them in your browser before you buy. Its creator introduced it on the three.js forum on October 19, and PC Gamer covered it the following day. It gives you a good sense of how each switch sounds; judging the feel still takes your own fingers.

What Switch Lab offers

  • 100 switches on an 87-key 3D keyboard. Type on your physical keyboard, click with the mouse or tap on your phone, with no sign-up.
  • Recordings of real switches, according to the creator, with playback speed varied by ±2% so repeated keystrokes don't sound identical.
  • Animated switch swaps and an inside view that shows the stem and spring moving.
  • A page for each switch with notes on who it suits, similar switches, weight, price and links to YouTube sound tests, as PC Gamer describes it.
  • Extras: typing practice (with a cat that occasionally walks across the board) and a typing marathon against other users' past runs.

The catalogue covers Cherry, Gateron, Outemu and other brands. There is a catch: PC Gamer reports that the first 40 switches unlock after you review the site or share it with a friend, and more open up through a daily login bonus.

What a recording can and can't tell you

A keyboard's sound isn't down to the switch alone. Keycap material, case, plate, internal foam, stabilizers and even your desk all change it. On top of that, what you hear has gone through a microphone and then through your own speakers or headphones.

That makes Switch Lab more useful for comparing switches against each other, all on the same virtual board under the same conditions, than for predicting exactly how your keyboard will sound. If one switch sounds deeper or crisper than another on the site, that difference will probably hold on your desk. The absolute volume, less so.

What audio can't convey is force or travel. Two switches can sound alike and feel completely different under your finger. For that you need the manufacturer's spec sheet (actuation force, pre-travel) and a clear idea of the type you want; our guide to linear, tactile and clicky switches covers it with real numbers.

How to use it with a hot-swap keyboard

  1. Pick the type first: linear, tactile or clicky. Listening to 100 switches without that filter only leads to indecision.
  2. Narrow it down to two or three candidates on Switch Lab, always with the same headphones at the same volume.
  3. Check compatibility: an MX hot-swap plate takes MX switches with 3 or 5 pins, depending on the plate; low-profile and optical switches use a different system.
  4. Buy a few rather than a full set and fit them on the keys you use most for a few days. Our hot-swap keyboard guide walks you through swapping them without solder.

What about a TESSEN?

The TESSEN keyboard ships with Gateron KS-3 Milky Pro Yellow switches, linear and lubricated, along with lubricated Gateron stabilizers and internal foam. Keep in mind that Switch Lab plays each switch on its own virtual board: the foam, lubricated stabilizers and PBT doubleshot keycaps in our build also shape the final sound.

If listening makes you want to try a different feel, the plate is hot-swap and takes 3- and 5-pin MX switches (not low-profile or optical), so you can change a handful of keys without soldering. And if it's the look you're after, the 3D configurator lets you paint every key in 8 colours and save the design with its own Design ID.

Sources

Keyboards

Keep reading

All newsAll guides